Latest articles / 13

Hot water heaters, panel radiators

The standard radiator valves have electrically-controlled actuators, which are produced in a variety of types (different sizes, power consumption, opening...

Recommended cables for the RS-485 communication

For the RS-485 interface and small distances (dozens of meters up to a 100 m) similar cables can be used, with at least two wires (preferably twisted): SYKFY...

Basic information on the interface RS-485

This type of interface makes it possible to connect up to 32 devices (some types of interfaces can be connected to several network participants) and it...

Serial communication interfaces RS-232, RS-485, RS-422, CAN and others

The CP-1000 basic module (similarly to other Foxtrot basic modules, e.g. CP-1006) is always fitted with the RS-232 communication interface terminated on...

Connecting peripheral FOXTROT modules by fibre-optic cable, the KB-0552 module

The KB-0552 modules for fibre-optic connection are designed to connect fibre-optic cables with the ST type of optical connectors. The module does not contain...

Connecting distant FOXTROT peripheral modules and the CIB MASTER module

Connection of distant FOXTROT peripheral modules (the TCL2 BUS without power supply)

Fig. 1. The basic wiring diagram of the TCL2 bus without power supply.

Connecting expansion modules to the FOXTROT system (the TCL2 buses with power supply)

The following figure .1 shows the basic connection of the expansion modules to the basic module. Peripheral modules are interconnected including the power...

TCL2 bus installation

Individual Foxtrot modules should be connected with cables intended for the RS-485 bus, the minimum of 2 pairs (for the connection of the communication...

TCL2 bus – the principles of design and installation

The peripheral modules on the TCL2 bus (e.g. IB-1301) of one PLC Foxtrot configuration (i.e. all peripheral modules controlled by one basic module) must...