Handling Modules and Assembling the TC800 System Mounting the TC800 module on a DIN rail with a system bus. The TC800 module (this applies to both 12 mm and 24 mm wide modules) is mounted on a DIN rail... RM-895x, TC800 system bus with KB-8961 terminators The RM-895x series system bus for the TC800 system is designed for mounting on a 35 mm DIN rail with a depth of 15 mm. The RM-895x series features... Examples of power connections for TC800 modules This article describes the correct examples of powering the modules (both internal and IO circuits) of the TC800 system. The PW-8901 power supply module... TC800 power supply sizing calculation and heat loss To determine the required performance of the power supplies for the VM and VIO levels, Table 1 lists the maximum power consumption (full load, excitation... Bus mounting information and TC800 assembly System bus in variants RM-8940 ÷ RM-8944 is mounted on a DIN rail with a TS35 depth of 7.5 mm. The DIN rail is not a standard part of the delivery... 17 pin spring connector for TC800 The 17-pin connectors of the TC800 common IO modules are standard removable connectors with a spring-clamp located on the removable part with a pitch of... Power supply modules PW-8901 and PW-8902 The PW-8901 power supply module is designed to power TECOMAT TC800 PLC assemblies from a 24 V DC network in a 24 mm wide case. It is a module that provides... SYSTEM BUS AND MECHANICAL DESIGN OF TC800 MODULES The supporting base of all TECOMAT TC800 PLC assemblies consists of a 35 mm DIN rail ČSN EN 50022, into which the system bus is inserted. The system bus...
