Installation, securing Cables for connecting temperature sensors, the SYKFY The SYKFY cables are suitable for connecting temperature sensors and for other measurements without high requirements for data transfer speed and transmitting... Installation, securing The ETHERNET outdoor installation (WiFi, cameras, and such like) For underground and outdoor installations, the ETHERLINE® CAT.5 FD BK cable can be used (produced by the LAPP GROUP). The cable meets the standards... Installation, securing A cable for the CIB bus, the J-Y(St)Y The CIB installations require shielded cables with twisted pairs, with the wire diameter of at least 0.6 mm, preferably 0.8mm, e.g. the JY(St)Y1x2x0.8,... Installation, securing Recommended cables The following articles list the recommended cable parameters for the CIB bus and other interfaces. Overvoltage protection Protection of TV signal distribution system (coax cables) The TV cable from the areal on the roof can be protected by the FX-090 B75 F/F (SALTEK) coaxial surge protection, or by the KO-10P (HAKEL), system, which... Overvoltage protection Protection of the Ethernet (the weather station, WiFi on the roof) To ensure surge protection of devices placed on the roof (under the roof) and connected to the Ethernet network, it is recommended to install the DL-1G... Overvoltage protection Surge protection of the RS-485 (RS-232) communication interface If there is a risk of overvoltage (parallel cabling), it is recommended to increase the resilience of the systems by using the surge protection (SPD) with... Overvoltage protection Protection of socket circuits The socket circuits can be protected by Type 3 of SPDs, either in the version with an HF filter (this is a better solution for sensitive electronics),... Overvoltage protection Coordination of SPD, decouplers The SPDs in the installation can only function properly if proper mutual coordination between them is provided - i.e. ensuring minimum required impedance... Overvoltage protection Protection of 1ph, 230 V devices, the LPZ 2/3 interface, Type 3 In order to protect a device powered from the 230V grid, you should install a surge suppressor in the control panel, which is as close as possible to the... … 19 20 21 22 23 24 25 26 27 …