Connecting the LineaMatic sliding gate

For controlling the LineaMatic sliding gate, an actuator produced by Hörmann can be used. The actuator basic control uses two signals - full opening or partial opening of the gate (about 1.5m) for the passage of people.

To control the gate it is recommended to use the C-OR-0202B module located at the gate. The module inputs can be used e.g. for the local control buttons, or for connecting the RF receiver outputs (if you want to use a remote control produced by a different manufacturer).

Fig. 1. An example of connecting the LineaMatic drive to the C-OR-0202B module

Notes:

1. The terminal block signals ("ext. Funk") Lineamatic:

   20 – GND,
   5 – 24 VDC output (maximum 500 mA),
   23 – a partial opening of the gate
   21 – impulse control (opening -stop-closing -stop).

2. A maximum distance of the relay module from the gate drive (the length of the cable) id 10 m.