English
R-OR-0201B is a module designed for remote control of devices in the RF network of the RFox2 system. The module contains 1x relay output and 2x AI / DI input.
Binary inputs DI1 and DI2 are intended for connection of a potential-free contact (button on the wall, etc.). The current when the input is closed is approx. 0.7 mA, the input circuit is supplied from an internal source of 3.3 V. The common terminal of inputs DI1 and DI2 is N (galvanically connected to the mains supply, conductor N).
The relay output is equipped with a relay with a changeover contact. It is equipped with a relay with a reinforced contact of 16 A.
The module is in a plastic BOX box.
CAUTION! Binary inputs DI1 and DI2 are galvanic connected to the mains supply of the module.
Basic parameters
| Communication interface |
RFox2 |
| Power voltage |
230 V AC +-10% |
| Internal security |
No |
| Typical power consumption |
2,8 W |
| Maximum power consumption |
4,6 W |
|
Coverage - ČSN EN 60529:1993 (idt IEC 529:1989) |
IPxxB |
|
Weight |
38 g |
|
Dimensions |
50 × 50 × 27 mm |
Operating parameters
|
Operating temperature range |
-20 °C .. +55 °C |
|
Permissible temperature during transport |
–25 °C .. +85 °C |
| Relative air humidity |
10 % .. 95 % without condensation |
| Atmospheric pressure |
min. 70 kPa (< 3000 m.n.m., over sea level) |
|
Degree of pollution – ČSN EN 60664-1:2008 (mod IEC 60664-1:2007) |
1 |
|
Overvoltage category of the installation – ČSN EN 60664-1:2008 (mod IEC 60664-1:2007) |
x |
|
Working position |
marked on the cover |
| Type of operation |
permanent |
RF interface parameters of the module
are listed in the article Basic parameters of RFox2 modules
Fig. 1 basic example of R-OR-0201B module connection