Connecting the OP10, OP30 and OP45 sensors to the C-WG-0503S module

Contact-free reading cards and similar identifiers in accordance with the standard 125 kHz can be also facilitated by the sensors OP10, OP30I, OP45 and other Honeywell products, which should be connected to the C-WG-0503S module.

The module provides powering the sensor, communication between the Wiegand and the sensor, and control LEDs and the buzzer.

Design:

OP10 a miniature design.

OP30 a narrow design for mounting next to the door frames.

OP45 a square design for mounting on a flush box.

The OP40 and OP90 should be connected in the same way.

Tab. 2. A description of signals of the OPxx sensor connectors

Fig. 1. The dimensions for mounting of the OP10 sensor (information in inches and mm)

The properties and parameters of the OP10, OP30 and OP45 sensors

The OPxx sensors are designed for contact-free reading (RFID) of 125 kHz identifiers.

The sensor is equipped with a two-colour LED indication and a buzzer.

The sensor is designed both for indoor and outdoor installation.

The sensor is mounted on the wall with two screws (approx. M3, or 3.5 mm wood screws); the layout of the mounting holes is indicated (in Fig. 1.) in the middle between the mounting holes in the rear wall there is a fixed connecting cable.

The cable is terminated with free coloured wires, see Tab. 1.

Tab. 1. The basic parameters of the OPxx sensors