A module with a higher protection with glands

The module is used in modules, which are located outdoors, in damp environment, etc. The module is made of grey UV resistant polycarbonate.

Mounting of the module:

The quick-release screws should be disengaged by pressing and turning 90 °, then the lid of the head can be taken off. A supply cable with the recommended diameter should be put through the gland and attached to the terminal block.

Put the lid back, screw in the quick-release screws, press them again and turn back 90 °. The assembly is completed and the sensor is ready for operation.

The actual box should be screwed on the wall or on some other surface, using two 3 x 30 screws. Make sure the sensor is facing downwards.