The wireless controllers RFox, the ABB Time design

This product has been discontinued.

In order to control the lighting, blinds, ventilation and similar applications, you can use the wireless controller R-WS-0200R with one fingerboard (2 buttons - one at the top and one below), or the R-WS-0400R with two fingerboards (4 buttons - each fingerboard has a button at the top and below); it is supplied as a standard RFox peripheral module. Both types of controllers are manufactured in ABB Time design; they are powered by a lithium battery CR2032 placed under the fingerboard (fingerboards). The design of the module is flat, which allows mounting on flat surfaces (gluing on glass), on the flush box or a wall, or even placing it loose.

Fig. 1. The design of the R-WS-0200R and the R-WS-0400R controllers

Notes:

1. The module consists of the fingerboards, electronics in the interjacent frame, a standard frame (the figure shows the ABB Element) and the supporting part (in the figure left to right).

2. The battery is in the upper left corner; it was disconnected in the factory with an insulating tape, which should be pulled out at the back when you are bonding the module to the system.

3. The supporting part has a flat rear wall, which can be glued or screwed onto flat surfaces (the holes have a standard 60 mm spacing).